Drums in HDPE

Drums in HDPE

CHEAP –  MAXIMUM SEAL  –  SEMI-TRANSPARENT  –  NO JOINTS  –  IMPACT RESISTANT

There are four drums, varying in capacity and measurement, manufactured in polyethylene (HDPE), a very low cost material to give considerable savings. This plastic has technical characteristics not only similar to those of stainless steel, to date the most used for suction drums, but also more performing than steel. Moulding using a blowing technique, for example, ensures the tank is free of joints, which are instead present using other methods or with steel.


We assure the total absence of failure areas, therefore the tank is completely sealed. HDPE does not deform if subjected to impact and strong pressure. Polyethylene is much lighter than other materials and is semi-transparent, allowing the level of liquid to be ascertained without opening the container each time.

TECHNICAL CHARACTERISTICS

The drums are in 4 standard formats, with 2 1/2” diameter filling caps with both vertical and horizontal positioning. Coupling of the power pack is standardised at a diameter of 123mm, according to conventional standards. Possibility of central or offset connector coupling.

HDPE is particularly resistant to:

    • Temperatures vary from -10°C to +90°C
    • Chemical substances
    • Strong impacts

ARTICLE CODE

60148

6148/1

60149

60149/1

60157

60157/1

60155

60155/1

60156

60156/1

CAPACITY (LT)

5

5

7

7

9

9

11

11

14

14

LENGHT (mm)

219

219

271

271

323

323

453

453

558

558

CONTAINER

195

195

195

195

195

195

195

195

195

195

CONNECTION

123

123

123

123

123

123

123

123

123

123

POSITIONING

HORIZ.

VERT.

HORIZ.

VERT.

HORIZ.

VERT.

HORIZ.

VERT.

HORIZ.

VERT.

In addition to the four sizes presented, PLASTIN is able to design, prototype and make on request, tanks of different sizes.

Contact us for a customized quote

New! Square Tanks

Available in four sizes