Drums in HDPE
- Home
- Drums in HDPE
Drums in HDPE





Drums in HDPE
CHEAP – MAXIMUM SEAL – SEMI-TRANSPARENT – NO JOINTS – IMPACT RESISTANT
There are four drums, varying in capacity and measurement, manufactured in polyethylene (HDPE), a very low cost material to give considerable savings. This plastic has technical characteristics not only similar to those of stainless steel, to date the most used for suction drums, but also more performing than steel. Moulding using a blowing technique, for example, ensures the tank is free of joints, which are instead present using other methods or with steel.
We assure the total absence of failure areas, therefore the tank is completely sealed. HDPE does not deform if subjected to impact and strong pressure. Polyethylene is much lighter than other materials and is semi-transparent, allowing the level of liquid to be ascertained without opening the container each time.
TECHNICAL CHARACTERISTICS
The drums are in 4 standard formats, with 2 1/2” diameter filling caps with both vertical and horizontal positioning. Coupling of the power pack is standardised at a diameter of 123mm, according to conventional standards. Possibility of central or offset connector coupling.
HDPE is particularly resistant to:
- Temperatures vary from -10°C to +90°C
- Chemical substances
- Strong impacts
ARTICLE CODE
60148
6148/1
60149
60149/1
60157
60157/1
60155
60155/1
60156
60156/1
CAPACITY (LT)
5
5
7
7
9
9
11
11
14
14
LENGHT (mm)
219
219
271
271
323
323
453
453
558
558
CONTAINER
195
195
195
195
195
195
195
195
195
195
CONNECTION
123
123
123
123
123
123
123
123
123
123
POSITIONING
HORIZ.
VERT.
HORIZ.
VERT.
HORIZ.
VERT.
HORIZ.
VERT.
HORIZ.
VERT.
In addition to the four sizes presented, PLASTIN is able to design, prototype and make on request, tanks of different sizes.
Contact us for a customized quote
New! Square Tanks
Available in four sizes



